The default setup is depicted above. Any changes must be reported to and approved by the tool responsible. Always report if there is a problem with the probe health.

• Cascade i67-100-GSG probes (will switch to MPI T67 in the future)
  • Always leave raised from chuck and separated from each other
  • Only to be replaced if damaged
  • Always ensure planarity w.r.t sample surface
  • Storage boxes with identifier and data are available at the station
• Junkosha MWX0 cables (1200 mm long) with 1.85 mm interfaces
  • Always leave connected to probes, but capped and not connected to instruments
  • Only to be used in the probe station
  • Do not bend (critical minimum radius 4 cm) or twist
  • Envelope with test data and connector caps are available at the station
• Karl Süss Probe Station
  • Always leave table in contact (lower) position
  • Do not put any stress on the table, it will move and destroy your sample and probes
  • Magnetically clamped probe positioners
  • Never use tape or glue, ever